Hot Junction Welding Machine
Hot Junction Welding Machine

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Hot Junction Welding Machine
 
Hot Junction Welding Machine
 
Hot Junction Welder
Resistivity Meter
Response Time Measurement Unit
Capacitor Discharge fine wire   Welding Machine
Capacitor Discharge Welding    Machine
Time Synchronising System
Quality Testing Devices
Digital Safety Ohms Meter
Siren Controller System
Stress Relieving / Calibration / Type    Testing – Cycling of
   Pressure Gauges

• Six Station Computerised PVC Pipe    testing Machine
• Memory Data Bank / Data Storage
• Weather Station
• Any Concept to Equipments
 
 
Hot Junction Welding Machine

Hot Junction Welding Machines For Mi Thermocouples

 

Hot Junction Welding Machine is most suitable to weld the Hot Junction of a SIMPLEX / DUPLEX / TRIPLEX ungrounded and grounded Mineral Insulated (MI) thermocouples of various types, and sizes ranging from 1 mm to 6 mm. Oxidization is totally avoided as the welding process takes just few milliseconds, and with inert Gas Atmosphere. The use of ARGON inert gas for pre weld and post weld times does not allow the junction to oxidize at all. The welding is done stored energy, rater than the current, forming a weld as a beautiful bright bulb, and is immune to power supply variations and changes.

 
 
Principal of Operation :
 
 
Hot Junction Welder For Mi Thermocouples
 
 
 
 
 

A Capacitor bank is charged to the required voltage, monitored digitally, depending on the Energy requirements, according to the size and type of thermocouple. Two more additional capacitor banks can be added for thick wires. Actuation of the START switch purges Argon for predefined time, (pre-welding), the ARC strikes, discharging Heavy current through the joint fusing the same, forming a bulb, thus completing the welding. The Argon continues to flow for predefined time (post weld time) cooling the thermocouple, avoiding oxidization. Same method is adopted for Duplex / Triplex Thermocouples, with fine adjustment of torch.
The thermocouple is prepared and adjusted properly, in a special fixture. Welding torch and can be moved in both X and Y direction with very fine Lead screw type of precise arrangement, for accurate positioning, for welding Simplex, Duplex, Triplex thermocouples. The UP / DOWN movement with locking facility allows the torch movement vertically. All these functions make the welding of DUPLEX / TRIPLEX Thermocouples without removal of the same. A Clip, is used to connect the other end of the thermocouple, forms the second electrode. A gap of about 0.5-to1.0 mm is adjusted between the junction and torch to avoid any contamination of the welding electrode, during welding. Welding can not take place, with indication, if the torch touches the junction.
The provision is made to adopt Microscope for inspection. The unit works on 230 / 110 V AC mains.

 
Hot Junction Welding Machin
 
 
 

 

 

Hot Junction Welder | Resistivity Meter | Response Time Measurement Unit | Capacitor Discharge fine wire Welding Machine | Capacitor Discharge Welding Machine | Time Synchronising System | Quality Testing Devices | Digital Safety Ohms Meter | Siren Controller System | Stress Relieving / Calibration / Type Testing – Cycling of
   Pressure Gauges
| Six Station Computerised PVC Pipe testing Machine | Memory Data Bank / Data Storage | Weather Station | Any Concept to Equipments | Solar Powered Constant Move Pivot Irrigator | Solar Powered Towable Single Tower Central Pivot Irrigator | Home | Contact us | Feedback | Sitemap

Designed by : MID   Hosted by : GID   Promoted by : PBD